External Signal. Connection; Initial Start-Up - GIRBAU HS-6013 Installation Instructions Manual

3.6. External signal. Connection

CAUTION!
Option available in Inteli Control models only.
To be able to use this option, the washing machine must be fitted with the A6 board, duly installed and activated
in the SETUP menu.
External signal. It is possible to use an order from the washing machine control to issue an end of program or
alarm warning.
See Inteli control Operation Manual for further information.
External signal specifications.
Free voltage contact between terminals X4-5 and X4-6 on the A6 board.
Maximum intensity allowed: 1A.
Maximum voltage: 240V.AC.

3.7. Initial start-up

THE WASHER MUST BE PUT INTO SERVICE BY AN AUTHORIZED TECHNICAL SERVICE.
Before the initial START-UP, make sure that you accomplish the following points:

Remove all packing materials. (Break them down in order to appropriately recycle them)

Remove all tools used during the installation.

Verify that all accessories have been removed from the drum interior.

Verify the correct installation of all the accessories necessary for the washer operation.

Check that the electrical installation corresponds with the voltage and the frequency of the machine.

Verify that the four washer feet come in contact with the floor.

Verify that all the shipping restraints are removed.

Connect all the water, steam (steam heated washers) and power inlets according to the technical
specifications.

Open the manual water inlet valves (and steam if necessary) and check for any leaks around the manual
flow valves and connection couplings.

Connect the electricity supply.

Check the operation (it is recommended to use the TEST program).

Keep the manual in a safe place and in good condition for its possible consultation.

Before washing clothes for the first time we recommend to run a complete cycle with detergent (1/4 the
normal recommended amount).
Installation
35
Cod.nº 429043
Rev. 15/1215