Water Supply - GIRBAU HS-6013 Installation Instructions Manual

3.2. Water supply

Hoses and pipes should be flushed through before being connected to the machine.
Install at each water supply and in an accessible location, a
mechanically interlocked water valve.
Refer to technical specifications on the INSTALLATION
SPECS, section 1.4
Assembling the filters and their connection (fig. 9)
Insert filter C and washer B inside each of the water inlet
couplings D
Assemble the couplings to the electrovalves A.
Place the E seals on the water inlet hoses F.
Put the water inlet hoses on the electrovalve couplings.
Open the manual valves and check for leaks in the
installation.
Arrangement of the hoses
The inlets are identified by the label posted at each inlet
(fig. 10).
The washer mixes hot and cold water according to the
temperature programmed. The use of hot/cold water allows
the machine to gain time and effectiveness in its washing
programs.
Inlet 1. The cold water must ALWAYS be connected.
The hose is marked with a blue line.
Inlet 2. Connect hot water. This hose is marked with a
red line.
Inlet 3. (This option is only available for Inteli Control).
Connect cold or hot water according to the
washer configuration. The hose is marked with
a red line.
DO NOT CONNECT THE HOT WATER TO INLET 1. THIS INLET DOES NOT HAVE A TEMPERATURE
CONTROL SYSTEM.
DO NOT CONNECT THE HOT WATER TO INLET 3 IF IT IS NOT CONFIGURED AS A DUAL HOT WATER
INLET FLOW.
INCOMPLIANCE OF THIS PRECAUTION CAN CAUSE FABRIC DAMAGE.
If there is no hot water supply, connect cold water or cold softened water to inlet 2.
INTELI control washing machines, ADAPT THE WASHER CONFIGURATION to operate with cold water.
Installation
17
fig. 9
fig. 10
Cod. 429043
Rev. 02/1206