Installation - GIRBAU HS-6013 Installation Instructions Manual

3. INSTALLATION

ALL CONNECTIONS FOR ELECTRICAL POWER AND PLUMBING MUST COMPLY WITH THE
STATUTORY SAFETY STANDARDS APPLICABLE TO EACH COUNTRY, AND BE MADE BY LICENSED
INSTALLERS ONLY.
3.1. Drain
Drain to the drain box. (Most recommended option)
Build a drain box (fig. 6) following the specifications indicated in the INSTALLATION SPECS, section 1.4.
Connect the drain elbow to the drain outlet and secure hose with the corresponding clamp (fig. 7).
Do not sink the free end of the drain elbow in the drain box:
•
To prevent dirty water siphoning to the washing machine.
•
To facilitate the water drain.
•
To detect water leaks through the drain
•
To prevent dirty water from coming into contact with the washer.
Direct connection of the washer drain to
the sewer (fig.8).
Facilities preferring this option to the open
box option (recommended option) must
respect the following precautions:
Provide next to the connection point of each
machine to the sewer, with a sewer
ventilation pipe A reaching the outside, set
at a height of 40 inch. (1000 mm) and
50mm (2 inch) diameter.
Drain trap diameter B: refer to table on
section 2.3. and figure 3.
The emptying of the drain trap to the sewer
system is done through an open drain box
(fig. 8/B and C) which prevents variations in
pressure and backflow to the drain. The end
of the drain trap must not be sunk in the
box.
Installation
fig 6
16
fig. 7
fig. 8
Cod. 429043
Rev. 02/1206