KTM 450 XC Owner's Manual page 95

MAINTENANCE ON CHASSIS AND ENGINE
–
Remove the four screws
ward and set it down.
–
Remove the nuts
–
Remove screws
–
Remove screws
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Place the handlebar bridge
and tighten screw
Guideline
Screw, steering bridge
–
Mount and tighten screw
Guideline
Screw, steering column, top
–
Mount and tighten screws
Guideline
100099-10
Screw, steering bridge
–
Mount the handlebar support
self-locking nuts
Guideline
Nut, handlebar support
. Remove the handlebar clamps

and remove the handlebar support

and .
 
. Remove the handlebar bridge

onto the steering column in the desired position. Mount

.

.

.

in the desired position using the screws. Mount new

and tighten.

, swing the handlebar for-

with the screws.

.

M8 20 Nm
(14.8 lbf ft)
M20x1.5 25 Nm
(18.4 lbf ft)
M8 20 Nm
(14.8 lbf ft)
M10 45 Nm
(33.2 lbf ft)
93