MAINTENANCE ON CHASSIS AND ENGINE
Removing wheel/wheels
9.50
Info
Proceed in the same way on the other wheels if necessary.
–
Remove the rear brake linings.
–
Remove screw
–
Press the brake piston back to its basic position and make sure that no brake fluid over-
flows from the brake fluid reservoir.
–
Mount the rear brake linings.
–
Top up the brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Check parts for damage and wear. Replace damaged or worn parts.
100070-10
–
Refit screw
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Pull handbrake lever, push the locking pawl
lever. (Figure 100006-10
x
(
p. 119)
with membrane
.
x
(
p. 120)
.
p. 194)
with membrane
.
p. 30)
downwards, and release the handbrake
123