Riding Through Water; Switching Off The Engine - KTM 450 XC Owner's Manual

RIDING INSTRUCTIONS

Riding through water

7.14

Switching off the engine

7.15
Info
There are three ways to switch off the engine.
Warning
Danger of accidents The vehicle can roll over when riding through deep water
with a strong current.
–
Avoid riding through deep water with a strong current.
Warning
Danger of accidents Reduced braking due to wet or dirty brakes.
–
Clean or dry dirty or wet brakes by riding and braking gently.
400302-01
Note
Engine failure When riding through deep water, water can enter into the engine
through the air filter and cause engine damage.
–
Only ride through water if it reaches no higher than the upper edge of the footrest.
–
Before riding through water, determine the depth and current of the water.
–
Ride slowly and negotiate around obstacles.
–
After riding through water, dry the brakes by lightly activating both brakes until normal
braking power is available again.
–
If the vehicle became submerged, an authorized KTM workshop must perform a thor-
ough check and comprehensive service. Do not start the engine.
57