Ricoh MP C6502 series Operation Manual page 437

Setting
Remote Address
Security Policy
Encapsulation Mode
IPsec Requirement Level
Description
Specify the address of the
IPsec transmission partner.
You can also specify an
address range.
Specify how IPsec is handled.
Specify the encapsulation
mode.
(auto setting)
Specify whether to only
transmit using IPsec, or to
allow cleartext transmission
when IPsec cannot be
established.
(auto setting)
Configuring IPsec
Setting value
The IPsec transmission
partner's IPv4 or IPv6 address.
If you are not setting an
address range, enter 32 after
an IPv4 address, or enter 128
after an IPv6 address.
• Apply
• Bypass
• Discard
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
Select the transport mode (this
has no bearing on the security
level).
If you specify "Tunnel", you
must then specify the "Tunnel
End Point", which are the
beginning and ending IP
addresses. Set the same
address for the beginning
point as you set in "Local
Address".
• Use When Possible
• Always Require
147