Table of Contents
Advertisement
supervisor
Specifying the User Lockout Function
1.
Log in as the machine administrator from Web Image Monitor.
2.
Point to [Device Management], and then click [Configuration].
3.
Click [User Lockout Policy] under "Security".
4.
Set "Lockout" to [Active].
5.
In the drop-down menu, select the number of login attempts to permit before applying
lockout.
6.
After lockout, if you want to cancel lockout after a specified time elapses, set "Lockout
Release Timer" to [Active].
7.
In the "Lock Out User for" field, enter the number of minutes until lockout is disabled.
8.
Click [OK].
User Lockout Policy is set.
9.
Log out.
Canceling Password Lockout
1.
Log in as the user administrator from Web Image Monitor.
2.
Point to [Device Management], and then click [Address Book].
3.
Select the locked out user's account.
4.
Click [Detail Input], and then click [Change].
5.
Set "Lockout" to [Inactive] under "Authentication Information".
6.
Click [OK].
7.
Log out.
• You can cancel the administrator and supervisor password lockout by turning the main power off
and then turning it back on again, or by canceling the setting in [Program/Change Administrator]
under [Configuration] in Web Image Monitor.
Locked out user
User Lockout Function
Unlocking administrator
machine administrator
69
Advertisement
Chapters
Table of Contents
Troubleshooting
