Network Settings; Dial Plan Settings - Yealink SIP-T46G Administrator's Manual

Administrator's Guide for SIP-T46G IP Phone
This section provides the sample configuration file necessary to configure the IP phone.
Any line starts with a pound sign (#) is considered to be a comment, unless the # is
contained within double quotes. For Boolean fields, 0 = disabled, 1 = enabled.
This file contains sample configurations for the <y000000000028>.cfg or <MAC>.cfg file.
The parameters included here are examples only. Not all possible parameters are
shown in the sample configuration file. You can configure or comment the values as you
required. The settings in the <y000000000028>.cfg file will be overridden by settings
which also appear in the <MAC>.cfg file.
T46G Sample Configuration File
#!version:1.0.0.1
#Note: This file header cannot be edited or deleted.

Network Settings

#
network.internet_port.type =
#Configure the WAN port type; 0-DHCP, 1-PPPoE, 2-Static IP Address.
#If the WAN port type is configured as DHCP, you do not need to set the
#following network parameters.
#If the WAN port type is configured as Static IP Address, configure the
#following parameters.
network.internet_port.ip =
network.internet_port.mask =
network.internet_port.gateway =
network.primary_dns=
network.secondary_dns =
#If the WAN port type is configured as PPPoE, configure the following
#parameters.
network.pppoe.user =
network.pppoe.password =

Dial Plan Settings

#
dialplan.area_code.code =
dialplan.area_code.min_len =
dialplan.area_code.max_len =
dialplan.area_code.line_id =
dialplan.block_out.number.1 =
dialplan.block_out.line_id.1 =
dialplan.dialnow.rule.X =
dialplan.dialnow.line_id.X =
412
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299