Yealink SIP-T46G Administrator's Manual page 189


Note
Procedure
IPv6 can be configured using the configuration files or locally.
Configuration File
Local
To configure IPv6 address assignment method via web user interface:
1.
2.
3.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
router is configured by the network administrator and sends out Router
Advertisement announcements onto the link. These announcements can allow the
on-link connected IP phone to configure itself with IPv6 address, as specified in RFC
4862.
Stateful DHCPv6: The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) has
been standardized by the IETF through RFC3315. DHCPv6 enables DHCP servers to
pass configuration parameters such as IPv6 network addresses to IPv6 nodes. It
offers the capability of automatic allocation of reusable network addresses and
additional configuration flexibility. This protocol is a stateful counterpart to ―IPv6
Stateless Address Autoconfiguration‖, and can be used separately or in addition to
the stateless autoconfiguration to obtain configuration parameters.
If the IP phone enables the SLAAC and DHCPv6 features both, the phone will obtain the
IP address from the SLAAC and obtain the other network parameters from DHCPv6.
<y000000000028>.cfg
Web User Interface
Click on Network->Basic.
Select the desired address mode (IPv6 or IPv4&IPv6) from the pull-down list of
Internet Port Mode.
In the IPv6 Config block, mark the DHCP or the Static IP Address radio box.
Configuring Advanced Features
Configure the IPv6 address
assignment method.
For more information, refer to
IPv6 on page 329.
Configure the IPv6 address
assignment method.
Navigate to:
http://<phoneIPAddress>/servl
et?p=network&q=load
177