Connecting To A Computer - Sekonic SR-2300 Manual

Connecting to a computer

This device is equipped with USB and RS-232C interfaces.
When connecting the OMR, you can use the USB or RS-232C interface. When connecting using
USB, use the USB driver software that came with this device.
When replacing the OMR SR-600 series with this device, you can use the RS-232C interface.
When using the RS-232C interface, set the same data transfer speed on this device and the
computer.
Set the computer data transfer speed by checking your computer or software manuals.
See the following pages to set the transfer speed for this device.
USB
Operating mode
Interface setting (device ID setting) .............................. P21
• See P.20 and later when using USB.
RS-232C
Operating mode
Interface settings
Setting baud rate ..................................................... P23
Setting cheracter bit length ...................................... P23
Setting parity ............................................................ P24
Setting stop bit ......................................................... P25
Setting flow control .................................................. P25
Setting character code ............................................. P26
• See P.22 and later when using RS-232C.
^
select SR-2300 mode ...................... P20
^
select SR-600 mode ........................ P22
Connecting to a computer
-19-