Size And Position Menu - Christie M Series User Manual

Section 3: Operation
• Analog Video Sources (3 wire sync on green) always have the options Default and Advanced. Video
sources use a look up table to determine their format based on video standards. The Advanced auto setup
selection measures the start pixel and start line whereas Default uses the table values as is.
3.6

Size and Position Menu

Increase or decrease the size of your image, change its
proportion (aspect ratio), move the image to a specific
area of the screen, and refine other related parameters.
Use Size and Position controls to match the image
precisely to the screen used at the site.
Refer to Using Slide bars and Other Controls
need help using any of the options and controls.
Changes made in the Size and Position menu are
applied immediately and are saved when you exit the
menu (press E
XIT
RESIZE PRESETS
The same resize presets are available to all HD and SXGA+ screen models. However, the graphics
NOTE:
used to describe each preset in this section are of the SXGA+ models only.
Resize Presets will display an image in its
native resolution (no resizing) or will resize
the image by maximizing either the height,
width or both height and width, or will resize
to the maximum size possible while keeping
the original aspect ratio.
Size, Position and Blanking parameters will
automatically adjust accordingly or, if
Blanking is set first, which defines an Active
Input Area; Resize Preset scaling will occur in
this region of interest only. Resizing options
are explained below.
3-18
or M ).
ENU
if you
F
IGURE
F
IGURE
3-17 S P
IZE AND OSITION
3-18 R P
ESIZE RESETS
M Series User Manual
020-100009-04 Rev. 1 (10-2009)
M
ENU