Christie M Series User Manual page 100

• To match reds, decrease "Red X" until full
field red screens match.
• To match greens, decrease "Green Y" until
full field green screens match.
• To match blues, increase both "Blue X" and
"Blue Y" until full field blue screens match.
For speed, enable the "Auto Color
NOTE:
Enable" check box. Each color coordinate
you select will then automatically trigger a
full field display of the corresponding color.
Alternatively, use the Color Saturation
menu for these adjustments or to fine tune.
These coordinate adjustments move the three
color points closer together (see below) to
establish a "shared" gamut attainable by all projectors in your group. Adjust only as necessary to ensure that
the resulting color palette is as large as possible. When done, you may need to adjust lamp power slightly.
7. All screens should now be color-matched. Apply this new "User" gamut to a source at any time by
selecting it in the "Select Color Adjustment" list accessed in the Advanced Image Settings menu.
Using the Color Saturation Menu for Color Matching
To use the Color Saturation menu to
match colors across multiple screens. In
the three Color Adjustment submenus
(Red, Green, Blue, and White—see
right), set all main values to 1000 and the
secondary values to 0, if applicable. Then
judge by eye and adjust the slide bars as
needed.
NOTE:
new x/y coordinates in the Color
Adjustments by X,Y menu.
For best results, use this menu after
doing the color adjustment procedure.
M Series User Manual
020-100009-04 Rev. 1 (10-2009)
Adjustments here define
F
IGURE
F 3-44 C M
IGURE OLOR ATCHING
Section 3: Operation
3-43 C A
OLOR DJUSTMENT
U C S
SING OLOR ATURATION
M
ENU
3-57