Christie M Series User Manual page 79

Section 3: Operation
• MENU TYPE
Select the Basic or Advanced menu type from this list box. The Advanced menu setting will give the menu
options. The Basic menu setting will give a small number of the most frequently used menu items.
• SPLASH SCREEN
Choose which splash screen is to be used; the default or user downloaded splash screen.
• CASCADING MENUS
Enable or disable cascading menus. When disabled, a single menu level will be displayed on the OSD at a
time.
Communications - Submenu
Defines and controls how single or multiple projectors are linked with each other and with a controlling device.
For detailed information refer to the Serial Command document provided in the Dealer Section of the Christie
Website, PN 020-100224-XX.
SERIAL OPTIONS - Submenu
• BAUD RATE
Determines the speed of communication to and from the projector on the RS-232 or RS-422 links. The
maximum rate for the RS-232 is 115200; for RS-422 it is 19200. Set the baud rate to match that of your
controlling device, such as your PC. Refer to the documentation for the controlling device to determine the
baud rate. In an existing network of projectors, if you discover that a projector has a different baud rate, use the
pull-down list and select the correct baud rate using the E
or R
K A
EY IGHT
• SERIAL FLOW CONTROL
Determines whether software flow control or no flow control is used when transmitting and receiving data on
the serial port.
• PROJECTOR ADDRESS
Enter a three-digit number (such as "001") to assign or change a number to the projector currently in use. If the
current projector already has a number assigned, that number will appear here (for example "004" in the menu
shown below. Numerical identity for projectors enables you to communicate with a single projector within a
multiple-projector application (see also P
make a mistake in assigning or changing the projector number, press E
projectors are being used and you want to adjust the color for individual projectors to create one seamless
image, you must assign different numbers for each projector to allow switching back and forth between
projectors while adjustments are being made.
• NETWORK ROUTING
Not applicable for stand-alone projectors or simple serial networks with only one type of controller and
NOTE:
linking.
3-36
. Serial communication is always eight data bits, no parity.
K
RROW EY
F
IGURE
key. Do not scroll this control with L
NTER
key in, 3.1 Using the Remote Keypad or Built-In
ROJ
3-32 N R
ETWORK OUTING
to cancel.
NOTE:
XIT
L
IST
020-100009-04 Rev. 1 (10-2009)
A
EFT RROW
Keypad). If you
When multiple
M Series User Manual