Christie M Series User Manual page 33

SETTING THE PROJECTOR'S IP ADDRESS, SUBNET MASK AND GATEWAY
Adjusting System Parameters and Advanced Controls.
CHANGING THE PORT#:
the projector be changed from its default of 3002. If so, enter a new port number in the Ethernet Settings menu
or include the new port#.
Separating Networks
By default, communications originating from one type of serial controller—RS-232 vs. RS-422 vs. Ethernet—
stay on the corresponding network path. A "Separate" setting indicates this separation for "Network Routing"
in the Communications menu, see
example, it will communicate only with the projector to which it is connected unless you change this setting to
either "RS-232 and RS-422 Joined" or "All Joined".
Communicating to all Ports
To relay all messages to all ports—RS-232, RS-422, and Ethernet—set the "Network Routing" option in the
Communications menu for each projector to "All Joined", see
configuration is useful if you are using a non-RS-232 controller with the RS-232 linking available between
these projectors. For example, you may want to use both an RS-422-compatible controller and an Ethernet-
connected PC for working with a network of projectors linked via their RS-232 in/out ports.
M Series User Manual
020-100009-04 Rev. 1 (10-2009)
F 2-23 E
IGURE THERNET
On some Ethernet networks, firewall restrictions may require that the port number of
Section 4 Web User
Section 2: Installation and Setup
N S
ETWORK ETUP
: See
Interface. If you are using an RS-422 controller, for
Section 4 Web User
Section 3.8 Configuration -
Interface. This
2-23