Christie M Series User Manual page 83

Section 3: Operation
Horizontal keystone is used to correct a keystoned image shape in which the left and right borders of the image
are unequal in length, and the top and bottom are slanted to one of the sides, see
Keystone.
All settings to adjust keystone are in the Geometry Correction submenu. Brightness Uniformity, Edge
Blending and Black Level Blending should be disabled before performing Keystone adjustments.
ADJUSTING AN IMAGE FOR KEYSTONE CORRECTION
1. Enable keystone adjustments by selecting Keystone from the Geometry Correction drop down list.
This will enable the controls for performing 1D or 2D keystone adjustments.
NOTE:
2. Select a Test Pattern.
3. Perform coarse keystone adjustment by using the Horizontal or Vertical Adjust setting. Use the left and
right arrow keys to make the adjustment.
be adjusted. The outside edge of a cursor will be the outside edge of the image. It may not be possible to
exactly match the screen dimensions with the Horizontal and Vertical Keystone controls, but these settings
can be refined when the 2D keystone settings are adjusted.
4. When adjustment of the corners is complete, select OK.
that the projector is "Processing request". The settings are applied to the displayed image, and will take
approximately 10 seconds. If Vertical Keystone adjustments have been made, starting to do any Horizontal
Keystone adjustments will erase the Vertical settings, and vice versa.
5. After the Horizontal or Vertical adjustments have been made, selecting 2D Keystone adjustments will
retain these settings. Fine adjustment can now be made by moving any single corner separately.
6. Use the arrow keys to move to the required corner.
7. Press E
NTER
8. Use the arrow keys to move the selected corner to match the screen.
9. Press E
NTER
10. Repeat Steps 6 to 9 to adjust all 4 corners until they match the screen.
11. Select OK to apply the new corner positions to the image.
approximately 10 seconds indicating that the projector is "Processing request".
Under certain combinations of extreme keystone co-ordinates and specific signal frequency, a keystoned image
may result that is outside the bandwidth limitations of the projector. When attempting to apply the keystone
settings, a message will pop up on the OSD, indicating that the bandwidth has been exceeded and the keystone
cannot be applied. The cursor co-ordinates for keystone adjustment will remain at the failed keystone position.
This will allow the user to make minor changes and attempt to reapply the corner settings. Either the co-
ordinates must be adjusted, or the free run frequency must be changed to fall within the allowed bandwidth.
3-40
F 3-34 H
IGURE
It is recommended to use the Grid test pattern.
NOTE:
to select the corner.
NOTE:
again, to save that position for the corner.
K
ORIZONTAL EYSTONE
The corner cursors are a guide as to how the image will
NOTE:
A message will be displayed indicating
NOTE:
The current corner will be displayed in red.
NOTE:
The current corner will be displayed in green.
NOTE:
Figure 3-34 Horizontal
A message will be displayed for
M Series User Manual
020-100009-04 Rev. 1 (10-2009)