Christie M Series User Manual page 73

Section 3: Operation
• SPLIT SCREEN
Allows a snap shot of the main image to be presented on the right side of the screen to allow
evaluation of advanced image processing features. All resizing controls are honoured on both images;
however, image processing controls only happen on the left side image. Changing inputs, channels or
test patterns will disable this control.
this control.
NOISE REDUCTION SETTINGS
• NOISE REDUCTION
Selects a filter sensitivity to noise. A higher value may improve noisy sources, but it will soften the image.
• BLOCK ARTIFACT REDUCTION
Locates and reduces block edges produced by discrete cosine transform (DCT) based compression processing.
• MOSQUITO NOISE REDUCTION
Reduces mosquito artifacts around sharp edges in DCT based compression by dynamically adapting to image
content.
COLOR SETTINGS
• SELECT COLOR ADJUSTMENT
Select the output color adjustment most suited to this input signal. The options include the following:
Max Drives - All color adjustments are turned off allowing the projector to run at maximum brightness.
Color Temperature - Allows you to specify a color temperature between 3200 and 9300 based on the setting
of the color temperature slidebar.
Expressed in degrees Kelvin [3200K, 5400K, etc.]. Lower numbers appear reddish white and higher numbers
appear bluish.
Standard settings are:
 9300K, is close to the white of many computer monitors
 6500K, is the standard for color video, in both standard and high definition forms
 5400K, is a standard for graphics and black and white video
 3200K, is useful if the projected image is to be filmed or shot as part of a studio set illuminated with
incandescent lights
For all color temperatures the color primaries; red, green, and blue are unchanged and reflect the native colors
of the projector.
SD Video and HD Video - Sets the output color to a specific standard value. Adjusts the colors; red, green,
blue, and white.
User# - Select 1 of 4 user defined sets of color adjustments; defined in the Configuration menu.
3-30
PIP and Tiling operation must be disabled prior to enabling
NOTE:
M Series User Manual
020-100009-04 Rev. 1 (10-2009)