For Your Installation - Honeywell NEXH4520HD-NET Installation Manual

1.2 For Your Installation

If the product is to be installed in cold places such as in a freezer, the piping pipes must be sealed
in silicone to prevent the ingress of fresh air into the housing. Otherwise, moist air from outside
may permeate the internal housing, causing moisture or water vapor to condense inside the
product due to temperature differences inside and outside the product.
1) Do not drop or apply excessive force on the product. It's a dynamic, Do not install near the location.
2) Do not install at high temperature (50°C or higher), low temperature (less than 10°C), or high
humidity. Risk of fire or electric shock.
3) If you are moving the already installed product to a location, you must first remove the power and
then move it or reinstall it.
4) Disconnect the camera's commercial power and network cable on a thunderstorm. Failure to do so
may result in a fire or damage to the product.
5) Do not install near heat sources such as direct sunlight or Radiate. May cause fire.
6) Install it in a well ventilated area.
7) Avoid the direction of extremely bright light such as direct sunlight. May damage image sensor
I have it.
8) Do not install water in a leak or splash area. Do not place objects filled with liquid, such as potting
on the product.
9) The main power plug must be kept intact at all times.
10) If used outdoors, the camera may be damp due to temperature differences between inside and
outside the unit. For this reason, it is recommended to install the camera indoors. When used
outdoors, use internal fans and heaters. Activate it.
11) Do not allow the LAN Ethernet cable to extend outside the building.
Before installation
The product installation must be performed in accordance with the applicable laws and regulations.
In case of lightning, proper protection must be installed to prevent damage to the network camera
due to voltage spikes.
All precautions for safety of network cameras should be observed.
If cleaning is required, you must shut down the network camera and power down the camera.
Only a soft dry cloth will be used, abrasive cleaners will be prohibited.
Do not repair the product yourself. High voltages may flow when the cover is opened and closed,
causing electric shock. The repair must be referred to our trained professional service personnel.
4