Table of Contents
Advertisement
WHA-GW-*
Configuration
Parameter
Write Join
Information
RTC Date
RTC Time
Network start
date
Network start
time
Allow new
Devices
Radio Power
Table 5.2Wireless Communication Parameters - Setup
5.4.2
Instrument List
Here you will find information on the devices within the WirelessHART network. The
Instrument List represents the Gateway's virtual I/O system (see chapter 2.2.3) and
displays the cached parameters and values of all sub devices.
Note!
The Instrument List is stored in a non-volatile memory. Card/channel number assignment
will remain the same after a Gateway power-up or software restart.
Note!
Please keep in mind that the dynamic values of each sub device (analogue value, PV, SV,
TV, QV) are only cached by the Gateway if the respective sub device publishes those
values (see chapter 2.2.4).
After a network restart, the Instrument List needs time to rebuild. During this time, some
information is set to 0 or replaced by wildcard characters.
Description
Stores the Network ID and Join Key to the Gateway.
Please read the information related to the network ID and
join key in this section including the security notes.
Available only online.
Real time clock (RTC) date setting for the network. Enter a
date (Format: <DD:MM:YYYY>).
Available only online.
Real time clock (RTC) time setting for the network. Enter a
time (Format: <hh:mm:ss>).
Available only online.
Shows the date at which the network was (re)started.
Format: DD:MM:YYYY.
Available only online.
Shows the time at which the network was (re)started.
Format: hh:mm:ss.
Available only online.
Specify if new devices are allowed to join the
WirelessHART network.
Power level of the Gateway's radio transmitter, which
should normally be set to 10 dBm. Observe local
restrictions for 2400 MHz equipment.
Default
-
–
-
–
all
10 dBm
51
Advertisement
Table of Contents
