Set Device Address - Pepperl+Fuchs WHA-GW Manual

WHA-GW-*
Operation
6.3.4

Set device address

The table in the Set device address window shows the WirelessHART devices in the
network. The device address is the device long tag stored in the device.
Note!
Additional functions > Set device address is available only online (connection to the
gateway and the WirelessHART device(s) active).
Note!
The Device Long Tag parameterized in the Set Device Address window must be identical
with the Device Long Tag of the same device parameterized in the Set DTM Address
window (see chapter 6.3.3). Otherwise the DTM is not able to establish a connection to the
device.
Figure 6.11Additional Functions > Set device address
Changing the device address
1. Place the cursor inside a cell of the Long Tag column.
2. Change the device long tag as required. You may change the long tags of several
devices at once, if needed.
3. To apply the new DTM address(es) press Update changed tags.
The new DTM addresses are stored to the devices.
77