Compaq AlphaServer ES45 1B Owner's Manual page 272

set alert
The set alert command sets the alert string that is transmitted through the
modem when an alert condition is detected.
Set the alert string to the phone number of the modem connected to the remote
system. The alert string is appended after the dial string, and the combined
string is sent to the modem.
The example shown below is generic. Because paging services vary, be sure to
listen to the options provided by the paging service to determine the appropriate
delay and the menu options.
RMC> set alert
Alert String: ,,,,,,5085553332#;
RMC>
For more information on the alert string, see Section 6.6.5.
set com1_mode
The set com1_mode command specifies the COM1 data flow paths, so that
data either passes through the RMC or bypasses it.
By default all data passes through the RMC. Data and control signals flow from
the system COM1 port, through the RMC, and to the active external port, either
the COM1 serial port (MMJ) or the 9-pin modem port. If a modem is connected,
the data goes to the modem. This mode is called Through mode.
You can enter the RMC from either the MMJ port or the modem port. Only one
session can be active at a time.
For modem connection, you can set the com1_mode environment variable to
allow data to partially or completely bypass the RMC. The bypass modes are
Snoop mode, Soft Bypass mode, and Firm Bypass mode. These modes disable
the local channel from sending characters to the system COM1 port. If the
com1_mode value has been set to soft_bypass or firm_bypass, and the sys-
tem is turned off, the mode reverts to Snoop.
6-34 ES45 Owner's Guide