Srm Environment Variables For Com1 - Compaq AlphaServer ES45 1B Owner's Manual

6.4

SRM Environment Variables for COM1

Several SRM environment variables allow you to set up the COM1 se-
rial port (MMJ) for use with the RMC.
You may need to set the following environment variables from the SRM console,
depending on how you decide to set up the RMC.
com1_baud
com1_flow
com1_mode
com1_modem
6-10 ES45 Owner's Guide
Sets the baud rate of the COM1 serial port and the
modem port. The default is 9600. See Chapter 5.
Specifies the flow control on the serial port. The de-
fault is software. See Chapter 5.
Specifies the COM1 data flow paths so that data ei-
ther flows through the RMC or bypasses it. This envi-
ronment variable can be set from either the SRM or
the RMC. See Section 6.8.
Specifies to the operating system whether or not a
modem is present. See Chapter 5.