Compaq AlphaServer ES45 1B Owner's Manual page 268

enable remote
The enable remote command enables remote access to the RMC modem port
by configuring the modem with the setting stored in the initialization string.
This command also allows the RMC to automatically dial the pager number set
with the set dial command upon detection of alert conditions.
Before you can enter the enable remote command, you must configure remote
dial-in by setting an RMC password and initialization string. See Section 6.6.4.
RMC> set password
RMC Password: ****
Verification: ****
RMC> set init
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
If the enable remote command fails, the following error message is displayed:
*** ERROR - enable failed ***
Check that the modem is connected and that you have set the initialization
string correctly.
env
The env command displays the system environmental status, including power
supplies, voltages, fans, and temperatures. If a fault has occurred, the reading
blinks.
See Section 6.6.2 for details and an example.
6-30 ES45 Owner's Guide