Compaq AlphaServer ES45 1B Owner's Manual page 271

The power on command does not turn on the system if the Power button on the
operator control panel is in the Off position. If you issue the command, the fol-
lowing message is displayed:
RMC> power on
Power button is OFF
quit
The quit command exits RMC and returns the terminal to the server's COM1
port.
You must enter the entire word for the command to take effect.
RMC> quit
Returning to COM port
reset
The reset command is equivalent to pushing the Reset button on the operator
control panel.
The reset command restarts the system. The terminal exits RMC and recon-
nects to the server's COM1 port. You must enter the entire word for the com-
mand to take effect.
RMC>reset
Returning to COM port
send alert
The send alert command forces an alert condition.
This command is used to test the setup of the dial-out alert function. It is is-
sued from the local terminal.
As long as no one connects to the modem and there is no alert pending, the alert
will be sent to the pager immediately.
If the pager does not receive the alert, recheck your setup.
RMC> send alert
Alert detected!
Remote Management 6-33