Lens Setup; Lamp Setup - Christie D4K2560 User Manual

Installation and Setup

Lens Setup

Keep fingers and other body parts away from the moving parts in the projector. Motors and
fans may start without warning. Tie back long hair, remove jewelry and loose clothing before
manually adjusting the projector. Failure to comply could result in death or serious injury.
The primary lens seals the projection head, preventing contaminants from entering the main
electronics area. Do not operate the projector without a lens installed. Use a lens plug when
installing or transporting the projector. Failure to comply may result in equipment damage.
1. Remove the projector shroud, as described above.
2. Install the lens, as described in
The lens system controls the physical positions of the lens using 3 motors. The motors can be moved
manually but software has been provided to allow for accurate and remote control of the lens
positions. See Work with Lenses

Lamp Setup

EXPLOSION HAZARD! Lamp installation must be performed by a qualified service
technician only. Wear authorized protective clothing whenever the lamp door is open and
when handling the lamp. Make sure those within the vicinity of the projector are also
wearing protective safety clothing. Never twist or bend the quartz lamp body. Use the
correct wattage lamp supplied by Christie. Failure to comply results in death or serious
injury.
The lamp position can be adjusted at any time, via a set of electronically controlled motors. There is
an optimal position for the lamp, with respect to the reflector and the integrator rod, that will result
in maximum brightness. This geometry is software controlled using the LampLOC calibration process.
16
Install the Projection Lens
on page 34.
on page 48.
D4K2560 User Manual
020-101076-01 Rev. 1 (06-2013)