Table of Contents
Advertisement
1B1-62 M162 ENGINE MECHANICAL
4. Turn the intake camshaft adjuster to the direction of camshaft
rotation by hard until it stops and then install the chain.
Notice
Make sure that the camshaft sprocket and timing chain
are aligned with marks.
Intake camshaft adjuster should be in retarded position.
5. Install the chain on the exhaust sprocket and tighten the
sprocket bolts.
Notice
Tightening Torque
Make sure that the camshaft sprocket and timing chain
are aligned with marks.
Replace the sprocket bolt with new one.
6. Install the chain tensioner and tighten it as specified.
Notice
Tightening Torque
7. Rotate the crankshaft 2 revolutions and check followings:
- TDC of no. 1 cylinder : OT
- Alignment between camshaft adjustment hole and
cylinder head surface.
- Alignments between timing chain and sprocket marks.
Notice
Turn the crankshaft in the direction of engine rotation.
Read just if not aligned.
1st step 18 - 22 Nm
2nd step 90° ± 5°
(1)
40 Nm
(2)
72 - 88 Nm
Advertisement
Chapters
Table of Contents
