Table of Contents
Advertisement
Fractal Audio Systems MFC-‐101 Manual
14.5 Axe-‐Fx II Looper Control Mode
Firmware 2.1 adds Axe-‐Fx II Looper Control Mode to the MFC-‐101. A brief overview follows.
The MFC-‐101's Axe-‐Fx Mode must be set to "II" (Axe-‐Fx II) for Looper Control Mode to operate.
Press and hold the REVEAL footswitch to enter Looper Control Mode. You can tap REVEAL again to exit and return
to Performance Mode at any time. It is possible to exit Looper Control Mode to change to another preset with a
LOOPER in it (or switch IAs on or off) without interrupting playback. A short tap can also be used to enter Looper
Control Mode – see section 12.5.24 on p. 70.
In Looper Control Mode, the MFC-‐101 display will indicate the current Looper function, or will show "PRESET HAS
NO LOOPER" if that is the case. Playback is indicated by an animation.
The footswitch functions of Looper Control mode are shown below. These functions cannot be moved, modified or
re-‐assigned. The Midi CC#s for these switches (also shown in the illustration) are likewise hard-‐coded to match the
default assignments for the corresponding functions in the Axe-‐Fx II (I/O:CTRL page).
Doc v3.0
Figure 14-‐1: Looper Control Mode Footswitch Functions
CHANGE LOG
79
Advertisement
Table of Contents
Need help?
Do you have a question about the MFC-101 MARK III and is the answer not in the manual?
Questions and answers