Delete  And  Reset  Factory  Settings - Fractal Audio MFC-101 MARK III Owner's Manual

Midi foot controller
Hide thumbs Also See for MFC-101 MARK III:
Table of Contents

Advertisement

Fractal  Audio  Systems  MFC-­‐101  Manual
12.5.26 Delete  and  Reset  Factory  Settings  
EDIT : SETUP : PAGE"
 (26x)    
Delete  is  used  to  Reset  all  or  some  of  the  MFC-­‐101  to  factory  settings.    
WARNING:  Deleting  MFC-­‐101  user  data  is  DESTRUCTIVE  and  cannot  be  undone!  
It  is  strongly  recommended  that  you  BACK  UP  user  data  prior  to  using  this  function.
 
INCR/DECR
Use  the  
 footswitches  to  select  a  general  target  for  initialization.  
PARAMETER
In  some  cases,  
The  parameter  values  for  each  field  are  detailed  below:  
Setting  
Notes  
nd
PRESET  
2
 parameter  selects  an  individual  Preset,  000-­‐127,  or  ALL  
nd
SONG  
2
 parameter  selects  an  individual  Song,  000-­‐100,  or  ALL  
nd
SET  
2
 parameter  selects  an  individual  Set,  00-­‐10,  or  ALL  
nd
IA  SWITCH  
2
 parameter  selects  an  individual  IA  Switch,  00-­‐43,  or  ALL  
nd
INT  CC  
2
 parameter  selects  an  individual  Internal  CC,  00-­‐17,  or  ALL  
AXE  PC  
Resets  the  entire  Axe-­‐Fx  Preset  Tx  Map  (12.4.3)  
PRESET  MAP  
Resets  the  entire  MFC-­‐101  Incoming  Program  Change  Map  (12.4.6)  
CONFIGURATION  
Resets  General  Configuration,  MIDI  Configuration,  and  External  Devices  Configuration  to  their  
default  values  as  listed  on  in  15.1:  Factory  Default  Settings,  on  page  82  
MFC-­‐101  
Resets  the  entire  MFC-­‐101  to  factory  default  settings  as  listed  in  15.1:  Factory  Default  Settings,  on  
page  82  
ENTER
Press  the  flashing  
 footswitch  to  delete  the  selected  item  and  initialize  with  factory  defaults.  
NOTE:  Due  to  increased  CPU  activity  during  deletion,  it  is  normal  for  LED  blinking  to  slow  or  even  stop.  
NOTE:  The  preset  will  re-­‐load  automatically  when  returning  to  PERFORMANCE  MODE  after  most  deletions.  
 
 
Doc  v3.0
   
 
nd
"  moves  to  a  2
 parameter  for  selection  of  a  specific  target  for  initialization.  
 
 
 
SETUP  MENU  REFERENCE  
PAGE
or  !
 (3x)  
 
71
 

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MFC-101 MARK III and is the answer not in the manual?

Table of Contents