Configuring Multipoint Calling; Setting Call Quality Preferences - Polycom VSX 7000 Administrator's Manual

VSX 7000 Series Administrator's Guide

Configuring Multipoint Calling

Setting Call Quality Preferences

72
Before placing multipoint calls, you must enter a multipoint software registration
key.
1. Go to System > Admin Settings > General Settings > Options.
Enter the multipoint key provided.
2.
For information about purchasing the multipoint call option, please contact your
Polycom distributor.
Use the Call Quality screens to customize bandwidth options for incoming and
outgoing calls.
1. Go to System > Admin Settings > Video Network > Call Quality.
2. Select your primary and secondary call type choices for calls being placed from
the local and global directories.
If the sites in your directory have both IP and ISDN numbers, these settings
determine your network preferences for placing the call.
3. Select to go to the Preferred Speeds screen and configure these settings:
Option
Preferred Speeds
for Placing Calls
Maximum Speeds
for Receiving Calls
4. Select to go to the Call Speeds screen and specify the call speeds to make
available to users, if you are allowing them to choose speeds on a call-by-call
basis.
Description
Determines the speeds that will be used for calls when
• Call Quality is set to Auto on the Home screen
• Call Quality option is not available for users
Allows you to restrict the bandwidth used when receiving calls.
If the far site attempts to call the system at a higher speed than
selected here, the call is re-negotiated at the speed specified in
this field.
www.polycom.com/videodocumentation