Setting The Call Answering Mode; Setting Passwords And Security Options - Polycom VSX 7000 Administrator's Manual

Setting the Call Answering Mode

Setting Passwords and Security Options

© Polycom, Inc.
1. Go to System > Admin Settings > General Settings > System Settings.
2. Select Auto-Answer Point to Point to set the answer mode for calls with one
site, or select Auto-Answer Multipoint to set the mode for calls with two or
more other sites.
3. Choose from the following:
• Yes – to answer calls automatically
• No – to answer calls manually
• Do Not Disturb – to refuse incoming calls automatically. The caller
receives a message that the site is unavailable.
1. Go to System > Admin Settings > General Settings > Security.
2. Configure these settings:
Setting
Admin Password
Meeting password
Enable Remote
Access
Description
Enter or change the Admin Password.
When the Admin Password is set, you must enter this password to
• make configuration changes not in the User Settings screen,
• update the software, or
• manage the system using the VSX web interface.
Specifies the password users must supply to join multipoint calls
on this system if the call uses the internal multipoint option, rather
than an external MCU.
This field can also be used to store a password required by
another system that this system calls. If a password is stored in
this field, you do not need to enter it at the time of the call; the VSX
system supplies it to the system that requires it.
Specifies whether to allow remote access to the system by
• FTP,
• Telnet, or
• VSX web interface.
Chapter 4 - Designing the User Experience
73