Configuring Ip Network Support; Specifying H.323 Settings - Polycom VSX 7000 Administrator's Manual

Configuring IP Network Support

Specifying H.323 Settings

© Polycom, Inc.
Use the following sections to configure the system so that users can place and
receive video calls using IP on your LAN or WAN:
H.323 Settings
Gatekeeper
Gateway
Quality of Service
Firewall
If your network uses a Gatekeeper, the system can automatically register its H.323
name and extension. This allows others to call the system by entering the H.323
name or extension instead of the IP address.
1. Go to System > Admin Settings > Video Network > IP Network > H.323
Settings.
2. Configure these settings:
Setting Description
Enable IP H.323 Specifies whether to allow IP dialing.
Display H.323 Lets users placing a gateway call enter the H.323 extension
Extension separately from the gateway ID.
If you do not check this box, users make gateway calls by entering
the call information in this format:
gateway ID + ## + extension
H.323 Name Specifies the name that gatekeepers and gateways use to identify
this system. You can make point-to-point calls using H.323 names
if both systems are registered to a gatekeeper.
The H.323 Name is the same as the System Name, unless you
change it. Your organization's dial plan may define the names you
can use.
H.323 Extension Specifies the extension that gatekeepers and gateways use to
(E.164) identify this system.
The default H.323 Extension is based on the system serial
number, but it can be changed. Your organization's dial plan may
define the extensions you can use.
Chapter 3 - Configuring Network Use
33