Control Options - Honeywell ACUIX User Manual

On-Screen Setup Menus

Control Options

92
Set Dome Name
1. Select 1 to program a
24-alphanumeric name for the dome.
2. Move the joystick up and down to
select the characters. Move the
joystick left or right to position the
cursor as desired.
3. Press Iris Open when you are finished
setting the Dome Name.
Display Dome Name
Select 2 to toggle the dome name display ON or OFF (default). If set to ON, the
programmed dome name displays on the monitor.
Change Dome Name Location
Select 3 to change the location of the dome
name on the monitor. The default position
is on the top left of the monitor.
Select 3 from the Main menu to set the
Control Options. Setting the Control
Options for the ACUIX dome includes
operation of the pan and tilt, auto focus,
programming alarms, programming the
default function, and defining the startup
state of the dome.
PASS
If the PASS function is ON, the pan and tilt speed range is a function of the lens zoom
angle. As the lens is zoomed in, the maximum pan and tilt speeds are reduced and the
low speed control is expanded.
To toggle PASS ON (default) or OFF, select 1 from the Control Options menu.
DOME NAME SETTINGS
'------------------------'
Use ↑ ↓ keys to enter name
IRIS CLOSE to Exit
******DOME NAME*******
↑ ↓ to position the name.
IRIS OPEN when done.
CONTROL OPTIONS
1 PASS ..................... ON
2 Auto-Pivot .............. OFF
3 Program Alarms
4 Set Pan and Tilt Options
5 Set Default Function
6 Auto Focus ................ Z
7 Preset Tour Auto Focus .. OFF
8 Change Address,Protocol
ESC to Exit