Freeze/Unfreeze Video; Flashback Operation; Nightshot Mode; Alarm Operation - Honeywell ACUIX User Manual

Operation and Programming with Honeywell Diamond Protocol

Freeze/Unfreeze Video

Flashback Operation

NightShot Mode

Alarm Operation

56
Press and hold Fn, then press F2 ( ) or 'freeze' to toggle the camera between freeze
mode on and freeze mode off.
Press and hold Fn, then press F3 (!) or press auto180 to operate the flashback function.
Press Aux or enter preset 99 to toggle the camera between nightshot mode on and
nightshot mode off. This option only works if the ACUIX configuration includes a day/night
camera.
The ACUIX has four alarm inputs that can be configured as normally open or closed. If the
contact deviates from normal, an alarm occurs. The ACUIX can be programmed (through
the on-screen setup menus) to activate a Preset, a Preset Tour, or Mimic Tour in response
to an alarm. Refer to Program
more information on programming alarms.
The alarms are sampled 16 times per second. After the alarm has been accepted, the
ACUIX determines if a function has been programmed for that alarm, and if that alarm is
enabled. If either of those conditions are not met, the alarm will be discarded. If both
conditions are met, the alarm is considered triggered. If no other alarm is in service, the
alarm is serviced. The function assigned to the alarm is performed. The ACUIX stays in
the state of this alarm until it is acknowledged. Any additional alarms that are triggered
are not serviced until the first alarm is acknowledged. If there is more than one alarm
waiting to be serviced, they are serviced in order of alarm number, starting with the lowest.
An alarm cannot be reactivated until it has been both acknowledged, and the contact
returned to normal. After acknowledgment and the contact change of state, the cycle can
begin again.
Alarms, page 93, in Chapter 7, On-Screen Setup Menus for