Set Default Function - Honeywell ACUIX User Manual

On-Screen Setup Menus
98
Note You must know the original positioning of Preset 0.
a. Exit (ESC) out of the ACUIX setup menus until you have manual control of the
ACUIX.
b. Send the ACUIX to Preset 0. If it does not go to the previously known position for
Preset 0, the offset function cannot be used.
c. Using the controller, position the ACUIX where Preset 0 should be.
d. Access the ACUIX Main menu, select 3 (Control Options), then select 4 (Pan and
Tilt Options), and then select 6 (Pan Offset).
e. Select 2 to set the Pan Offset. To test the setting, reposition the ACUIX, then send
the ACUIX to Preset 0. The ACUIX should return to the position you have
programmed in step c.
f. Press ESC to exit the Pan and Tilt Options menu.
Startup State Restore
If the ACUIX loses power, the function the ACUIX was performing at the time can be
restored when power is returned. For example, this feature is turned on and the ACUIX was
performing a Preset Tour when it lost power. When power is restored, the ACUIX will find
home and then start the Preset Tour. The default setting is OFF. If the ACUIX loses power,
it will operate as defined in
Select 7 in the Pan and Tilt Options menu to
toggle ON and OFF. If changing from OFF
(default) to ON, a message displays to
confirm your selection. Select Y (yes), when
prompted, to turn this feature On. To leave
this feature Off, select N (no), when
prompted.

Set Default Function

Select 5 from the Control Options menu to
set the default function. The Default Function
can be enabled or disabled.
To set the Default Function, enter values in
the fields as defined in Table 7-6
Enter when done.
Find Home on Startup on page 97.
****Extreme Caution****
This will move the dome to
previous shutdown position
on startup.
-Y/N-
ESC to Exit
DEFAULT FUNCTION SETUP
FUN
-
PVT
and select
Press Enter when done.
Are you sure that you
want to do this?
NUM DLY ENA
--- --:-- -
MIN:SEC Y-N