Privacy Zones - Honeywell ACUIX User Manual

Privacy Zones

Document 800-01023 Rev A
02/08
List Programmed Sectors
A list of the programmed sectors can be viewed for each ACUIX. The list displays the
Sector numbers and titles. Sector IDs cannot be revised from the display.
1. Press Dome Menu.
Press + or - until Sector/Priv Menu displays on the LCD.
2.
3. Press Enter.
Press + or - until List displays on the LCD.
4.
5. Press Enter.
The controller LCD display shows the command Page Down. Press Enter to view
6.
more pages of the listing. When you have reached the end of the listing, End of
Directory displays on the monitor. To go back to the first page of the listing,
press Enter.
7. When you are finished viewing the Sector listing, press Clear/Manual.
All Privacy Zone programming is password protected when using Diamond protocol. The
password is user-programmable for up to 22 alphanumeric characters.
Privacy Zones are used so an operator cannot view the scene where the camera lens is
positioned. Whenever an operator positions the camera so that any portion of a
programmed Privacy Zone would be visible in the video, the video blanks. If a unit is sent
to a Preset that has been programmed so that any portion of a Privacy Zone would be
visible, the Preset title displays on the monitor, but the video is blanked. If a unit is sent to
a Preset and any portion of a Privacy Zone would be visible while traveling to the Preset,
the video is blanked when any portion of a Privacy Zone would be visible.
Note Upon powering up, the ACUIX dome automatically finds home so the dome
can then run Presets and so on as they were programmed. If a Privacy Zone
is enabled, no video is shown during homing, as your Privacy Zones are not
recognized until ACUIX has reached home. Video displays once the dome
has reached its home setting, unless a Privacy Zone overlaps with the home
setting.
The ACUIX stores the Privacy Zone data in nonvolatile memory, which will save the data
when the ACUIX is not powered. If Privacy Zones have been programmed and the unit
loses power, the video is blanked upon power-up until the unit finds a home to prevent
any Privacy Zones being visible. Any command to move the ACUIX causes the unit to find
home. If any portion of a Privacy Zone would be visible when the unit is at its home
position, the video remains blank until the operator manually moves the ACUIX so that no
portion of a Privacy Zone would be visible.
ACUIX High Speed Dome User Manual
51