Honeywell ACUIX User Manual page 70

Operation and Programming with Honeywell VCL Protocol
70
Caution VCL protocol does not provide password protection for Privacy
Zones as described for Diamond protocol. Privacy Zones are
programmed through the on-screen setup menus. For password
protection, the password feature (described in
Password Feature) must be enabled.
Note Upon powering up, the ACUIX dome will automatically find home so the
dome can then run Presets and so on as they were programmed. If a Privacy
Zone is enabled, no video will be shown during homing, as your Privacy
Zones are not recognized until ACUIX has reached home. Video will display
once the dome has reached its home setting, unless a Privacy Zone overlaps
with the home setting.
When using VCL protocol, Privacy Zones must be programmed using the on-screen
setup menu.
1. Position the camera so the area to be covered by the Privacy Zone is viewed on the
monitor.
2. Press and hold 'Lock', then press 'F6' ('Menu') and then press 'aux' to enter the
ACUIX dome menu.
Use the tilt down function on the joystick until 6 Function Programming is
3.
highlighted, and then press Iris Open.
Use the tilt down function on the joystick until 6 Program Privacy Zone is
4.
highlighted, and then press Iris Open.
5. Use the tilt up function on the joystick until the desired Privacy Zone number (1–32)
displays, and then press Iris Open. Use the pan left and pan right functions to move
between the digits, if necessary.
6. Use the joystick tilt up and down functions to heighten the Privacy Zone box and the
joystick pan left and right functions to widen the box.
7. When the box is the desired size, press Iris Open.
8. Program another Privacy Zone or press Iris Close to exit programming.
Chapter 6, ACUIX