Operation and Programming with Honeywell VCL Protocol
Reset ACUIX
Manual Control
62
The ACUIX can be reset through the setup menu or by a Preset command.
To reset the ACUIX through the setup menu:
1.
Send the ACUIX to Preset 90 to access the setup menus.
Push the joystick down until 4 Diagnostics Menu is highlighted, then press Iris
2.
Open.
Push the joystick down until the 7 Scan and Camera Reset option is
3.
highlighted and then press Iris Open.
Note
If the Autofocus is OFF when the setup menus are accessed — by sending
the ACUIX to Preset 90 — the Autofocus is automatically enabled.
Manual control of the ACUIX when using VCL protocol with the HJZTP controller is the
same as described in
Chapter 3, Operation and Programming with Honeywell Diamond
Protocol.
Table 4-1
HJZTP Joystick Operation
Control
Function
Joystick up
Tilt up
Joystick down
Tilt down
Joystick left
Pan left
Joystick right
Pan right
The speed of pan and tilt is relative to the amount of
movement applied to the joystick.
Joystick Knob
Rotate the joystick knob clockwise and counterclockwise
to perform the zoom in and out functions, respectively.
The manual speed of the zoom function is set through the
on-screen setup menus under Camera Options.