Mendota Designer Fronts Installation Information - Mendota DXV-60 Installation & Operating Instructions Manual

MENDOTA DESIGNER FRONTS INSTALLATION INFORMATION

The following Designer Fronts are available for the DXV-60 Fireplace:
1. Andover, Bentley Arched Door Kit or Prairie Rectangular Door kit with Fire screen with optional Overlays as listed below:
a. Black Overlay
b. Pewter Overlay
c. Antique Copper Overlay
d. 24K Gold
2. Deerfield Cast Scrolls Front
3. Wellington Firescreen Front
4. Black or 24K Gold Victoria Filigree
5. Black or 24K Gold Tuscany Filigree
6. Millenia Flat Grills in two optional color schemes as listed below:
a. Black Millenia Flat Grills
b. Full Brass Millenia Flat Grills
Information specific to the installation of the Andover, Bentley and Prairie Fronts
The Andover Door, Bentley Door and Prairie Door Fronts are designed to be "Full-Face" trim kits. These two Fronts cover an area
equivalent to that shown in the diagram below. Any material that protrudes into this area on the sides, top or bottom edges can only
be flush with the front surface of the fireplace faceplate.
If planning to install either the Andover Door or the Prairie Door Front, DO NOT COVER THE FACEPLATE OF THE
FIREPLACE WITH ANY MATERIALS. Furthermore, any drywall or wall covering material that is adjacent to the sides, top or
bottom of the Fireplace's faceplate may not protrude out past the front surface of the Fireplace Faceplate's front surface.
The Andover, Bentley and Prairie Doors Mounting Faceplate (required for installation of
the Andover, Bentley and Prairie Doors) may be covered over with noncombustible facing
materials. See Figure below.
To install Tile, Marble, Slate, Stone, Rocks
or other noncombustible facings to enhance
the arch shape of the Andover Doors or the
Rectangular shape of the Prairie Doors, do
so only after the Andover or Prairie Door
Kits have been installed on the DXV-60
Fireplace.
WARNING: COMBUSTIBLE
MATERIALS MUST NOT COVER THE
FRONT SURFACE OF THE
FIREPLACE'S FACEPLATE.
19