Ethernet Interface; Table 3-5. Usb2 And Usb3 Interface Pin Signals (J13); Table 3-6. Ethernet Interface Pin/Signal Descriptions (J3) - ADLINK Technology CoreModule 730 Reference Manual

Chapter 3
Table 3-5 describes the pin signals of the USB2 and USB3 header which consists of 10 right-angle pins in
two rows, with odd/even (1, 2) pin sequence, and 0.079" (2mm) pitch.

Table 3-5. USB2 and USB3 Interface Pin Signals (J13)

Pin # Signal
1 USB-PWR_2
2 USB-PWR_3
3 CONN_USB2_N
4 CONN_USB3_N
5 CONN_USB2_P
6 CONN_USB3_P
7 USB_GND2
8 USB_GND3
9 USB_GND2
10 USB_GND3
Note: The shaded areas denote power or ground.

Ethernet Interface

The Ethernet solution originates from the 82574IT Gigabit Ethernet controller and consists of both the
Media Access Controller (MAC) and the Physical Layer (PHY) combined into a single component solution.
The Gigabit Ethernet Control Unit is a 64-bit PCIe controller that features enhanced scatter-gather bus
mastering capabilities, which enables the processor to perform high-speed data transfers over the internal
PCIe bus. The bus master capabilities enable the component to process high-level commands and perform
multiple operations, thereby off-loading communication tasks from the CPU. The Ethernet interface offers
the following features:
•
Full duplex or half duplex support at 10 Mbps, 100 Mbps, or 1000 Mbps
•
In full duplex mode, the Ethernet controller adheres to the IEEE 802.3x Flow Control specification.
•
In half duplex mode, performance is enhanced by a proprietary collision reduction mechanism.
•
IEEE 802.3 compatible physical layer to wire transformer
•
IEEE 802.3u Auto-Negotiation support
•
Fast back-to-back transmission support with minimum interframe spacing (IFS).
•
IEEE 802.3x auto-negotiation support for speed and duplex operation
•
3 kB transmit and 3 kB receive FIFOs (helps prevent data underflow and overflow)
•
On-board magnetics (Ethernet isolation transformer)
Table 3-6 describes the pin signals of the Ethernet header which consists of 10 right-angle pins, two rows,
odd/even (1,2) pin sequence, and 0.079" (2mm) pitch.

Table 3-6. Ethernet Interface Pin/Signal Descriptions (J3)

Pin # Signal
1 GND
2 GND
3 MDI0+
4 MDI0-
20
Description
USB2 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
USB3 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
USB2 Port Data Negative
USB3 Port Data Negative
USB2 Port Data Positive
USB3 Port Data Positive
USB2 Ground
USB3 Ground
USB2 Ground
USB3 Ground
Description
Ground
Media Dependent Interface 0 +/-
Reference Manual
Hardware
CoreModule 730