Lap Registration Function - Ducati Multistrada 1200 ABS Owner's Manual

LAP registration function

E
This function describes the "LAP" time registration.
If the function is activated (see "LAP activation/deactivation
description"), the lap time can be registered as follows:
- the first time the flash is pressed (13, fig. 4) starts the
"lap timer" for the first lap and the instrument panel
shows the "START LAP" indication on the circular display
(B, fig. 6) for 4 seconds and then returns to the
"previous" display;
- from this moment, each time that the flash is pressed
(13, fig. 4) the circular display (B, fig. 6) automatically
shows the lap time for 10 seconds and then returns to
the "previous" display.
You can save a maximum of 30 laps in the memory.
If the memory is full, each time you press the flash button
(13, fig. 4), the instrument panel will not store any more lap
times and will show the flashing message "LAP MEMORY
FULL" on the circular display (B, fig. 6) for 3 seconds until the
times are reset.
When the LAP function is set disabled, the current "lap" is
not stored.
If the LAP function is active and suddenly the motorcycle is
suddenly turned off (Key-Off), the function will be
automatically disabled (even if the lap timer was active, the
current "lap" is not stored).
If the time is never "stopped", it will roll over upon reaching
9 minutes, 59 seconds and 99 hundredths; the lap timer
starts counting from 0 (zero) and will keep running until the
function is disabled.
74
If however the LAP function is switched on and the memory
has not been cleared, but fewer than 30 laps have been
saved (e.g. 18 laps), the instrument panel will store any
remaining laps until the memory is full (in this case, it will
store an additional 12 laps).
This function only displays the times for the lap being
registered; but other data are also saved (MAX speed, MAX
rpm, rev limiter if reached) for viewing at a later date in the
Lap Memory function (stored LAP display).