Rear brake pedal
loosen counter nut (7).
Turn pedal travel adjusting screw (6) until pedal is in the
Tighten the counter nut (7).
Operate the pedal by hand to check that there is 1.5 to 2 mm
of freeplay before the brake bites.
If not, adjust the length of the master cylinder pushrod as
Slacken off the counter nut (10) on the pushrod.
Screw the pushrod (8) into the clevis (9) to increase the
freeplay, or screw it out to reduce it.
Tighten the counter nut (10) and recheck the pedal freeplay.