Lap Registration Function - Ducati Diavel Carbon Owner's Manual

LAP registration function

This function describes the "LAP" time recording
procedure.
If the function was Enabled (see "LAP enabling /
disabling" page 107) lap time can be recorded as
follows:
- the first time rider presses the flash (3) button,
the "timer" of the first lap starts and "LAP START"
will be displayed flashing on the instrument panel
for 4 seconds, then the "previous" screen will
appear again;
- from this moment onwards, every time the flash
button (3) is pressed, the display automatically
shows for 10 seconds the number and time of
the lap, then goes back to the "previous" screen.
30 laps max. can be recorded. If memory is full,
whenever the flash button (3) is pressed, the
instrument panel does not record any lap time and
"LAP FULL" will be displayed flashing for 4 seconds
until lap times are reset.
When the "LAP" function is disabled, the current "lap"
is not recorded. If the LAP function is enabled and
vehicle is suddenly stopped (Key-Off), the function
will be automatically disabled (even if timer was
active, the current "lap" will not be recorded). If the
time is never "stopped", it will roll over upon reaching
9 minutes, 59 seconds and 99 hundredths; the lap
timer starts counting from 0 (zero) and will keep
running until the recording function is disabled. If, on
the contrary, the LAP function is enabled and
"memory" was not reset, but recorded laps are less
than 30 (example: 18 recorded laps) the Instrument
Panel records any left lap until memory is full (in this
case 12 further laps can be recorded). In this function
only the lap times being recorded are displayed; other
data are anyway recorded (MAX speed and MAX
rpm), which can be later displayed in the "LAP DATA"
(recorded LAP displaying) function.
109