"REAR" adjustment
E
- the top of the circular display (B, fig. 6) will show the set
compression [C.] and rebound [R.];
- use buttons (1, fig. 7) "▲" and (2, fig. 7) "▼" to select
the parameter to change and press the reset button (14,
fig. 4);
- the number to be changed is shown on the display;
- buttons (1, fig. 7) "▲" and (2, fig. 7) "▼" can increase or
decrease the number (between 1 and 32);
- press the reset button (14, fig. 4) to confirm the new
level.
Note
Increasing the set value "decreases" the hydraulic
"braking"; decreasing the value "increases" the hydraulic
"braking" of the shock absorber.
At this point, store the new setting by pressing the reset
button (14, fig. 4) for 3 seconds with "MEMORY" displayed.
The upper indication [C.] or [R.] will be updated to confirm
that the new setting was "received" and stored.
To exit the function, select "EXIT" and press the reset button
(14, fig. 4).
64