Immobilizer override procedure
This procedure makes it possible to "temporarily" turn on
the motorcycle if the HF (Hands Free) System is not working.
The PIN CODE function must be activated by entering
your 4 digit PIN in the instrument panel, otherwise the
vehicle cannot be turned on temporarily in the case of a
The motorcycle owner must activate (store) the PIN
code; if there is already a stored PIN, contact an Authorised
Ducati dealer to have the function "reset". To perform this
procedure, the Authorised Ducati Dealer may ask you to
demonstrate that you are the owner of the motorcycle.
PIN CODE activation function
To display the function, enter the "setting" menu page 46
and access the "PIN CODE" page.
If "MODIFY" appears when accessing this function,
this means that there is already a stored PIN and therefore
the function is already active.
When accessing the function, "NEW PIN" four dashes
"- - - -" will appear on the circular display (B, fig. 6); now enter
a 4 digit code.
Entering the code:
each time you press the button (2, fig. 7) "▼" the displayed
number increases from "0" to "9" and then returns to "0";
to confirm the number, press the reset button (14, fig. 4).
Repeat the procedure until inserting the fourth digit.
Press the reset button (14, fig. 4) again to confirm.
"OK" and "EXIT" will appear on the display.
To confirm the PIN that was entered, press the reset button
(14, fig. 4) again showing "OK".
"NEW PIN MEM" will appear on the display for 3 seconds to
confirm that the PIN was stored.
At the end of the 3 seconds, the instrument panel exits
automatically from the display and returns to the "setting"
From this moment, "MODIFY" will be displayed when
accessing the "PIN CODE" function and the PIN can be