Lap Registration Function - Ducati Diavel Carbon ABS Owner's Manual

LAP registration function

E
This function describes the "LAP" time registration.
If the function is activated (see "LAP activation/deactivation
description), the lap time can be registered as follows:
- pressing the flash headlight button (11, fig. 12) the first
time starts the "lap timer" for the first lap, and the
dashboard shows the message "LAP-START" flashing
for 4 seconds, and then returns to the previous display;
- from this moment, each time that the flash is pressed
(11, fig. 12) the display automatically shows the lap
number and lap time for 10 seconds and then returns to
the "previous" display.
You can save a maximum of 30 laps in the memory.
Once the memory is full, the dashboard no longer stores lap
times when the flash headlight button (11, fig. 12) is pressed,
and the flashing message "LAP-FULL" is shown on the
display for 4 seconds until the times are reset.
When the LAP function is set disabled, the current "lap" is
not stored.
If the LAP function is active and suddenly the motorcycle is
suddenly turned off (Key-Off), the function will be
automatically disabled (even if the lap timer was active, the
current "lap" is not stored).
If the time is never "stopped", it will roll over upon reaching
9 minutes, 59 seconds and 99 hundredths; the lap timer
starts counting from 0 (zero) and will keep running until the
function is disabled.
If however the LAP function is switched on and the memory
has not been cleared, but fewer than 30 laps have been
saved (e.g. 18 laps), the dashboard will store any remaining
70
laps until the memory is full (in this case, it will store an
additional 12 laps).
This function only displays the times for the lap being
registered; but other data are also saved (MAX speed and
MAX rpm) for viewing at a later date in the "LAP DATA"
function (stored LAP display).