Lap Registration Function - Ducati DIAVEL Owner's Manual

LAP registration function

This function describes the "LAP" time recording
procedure.
If the function was Enabled (see "LAP enabling /
disabling" page 94) lap time can be recorded as
follows:
- the first time rider presses the flash (3) button,
the "timer" of the first lap starts and "LAP START"
will be displayed flashing on the instrument panel
for 4 seconds, then the "previous" screen will
appear again;
- from this moment onwards, every time the flash
button (3) is pressed, the display automatically
shows for 10 seconds the number and time of
the lap, then goes back to the "previous" screen.
30 laps max. can be recorded. If memory is full,
whenever the flash button (3) is pressed, the
instrument panel does not record any lap time and
"LAP FULL" will be displayed flashing for 4 seconds
until lap times are reset.
When the "LAP" function is disabled, the current "lap"
is not recorded. If the LAP function is enabled and
vehicle is suddenly stopped (Key-Off), function will be
automatically disabled (even if timer was active, the
96
current "lap" will not be recorded). If the time is never
"stopped", it will roll over upon reaching 9 minutes, 59
seconds and 99 hundredths; the lap timer starts
counting from 0 (zero) and will keep running until the
recording function is disabled. If, on the contrary, the
LAP function is enabled and "memory" was not reset,
but recorded laps are less than 30 (example: 18
recorded laps) the Instrument Panel records any left
lap until memory is full (in this case 12 further laps
can be recorded). In this function only the lap times
being recorded are displayed; other data are anyway
recorded (MAX speed and MAX rpm), which can be
later displayed in the "LAP DATA" (recorded LAP
displaying) function.