Rear Turn Signals - Ducati Multistrada 1200 ABS Owner's Manual

Refitting
When refitting, turn the bulb holder (6) clockwise to lock it
into the headlight body.
Reconnect the connector (5) and refit the structures that
were removed being careful to insert the tabs (B, fig. 156)
into the slots (A, fig. 155) made in the top fairing.
Note
To replace the parking light LED bulb, contact an
Authorised Ducati Service Centre.

Rear turn signals

(fig. 157)
Remove the screw (1) and detach the glass (2) from the
indicator body holder.
The bulb has a bayonet-type end fitting: to remove it, push it
in and turn it counter-clockwise. Push in the new bulb and
turn it clockwise until it clicks into place. Refit the cup (2) by
inserting the tab into the corresponding slot in the turn signal
support.
and tighten the screw (1).
4
2
1
E
B
fig. 156
2
fig. 157
155