Loader Valve Removal And Installation; Loader Valve Removal - Terex PT-30 Service Manual

Compact Track Loader
9. Loader/Transmission Controls
Figure 9-9
3. Use an allen (hex) wrench to remove the bolt
securing the magnet to the joystick.
Figure 9-10
4. Lift the joystick out of the mounting bracket slightly
to allow the magnet connector to pass between
them, then remove the magnet.
5. To install the float magnet, reverse the removal
procedure.
Loader Valve Removal and
Installation
The tools required for loader valve removal and in-stal-
lation are listed in Table 9 3. Use manufacturer-recom-
mended tools whenever possible.
Table 9-3
Required Tools
Combination Wrenches

Loader Valve Removal

Hot oil can cause personal injury. Lower all
attach-ments and make sure the oil is cool
before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and the filler cap is cool enough to touch
with your hands.
Collect and contain liquids in a suitable con-
tainer. Dispose of all liquids according to local
regulations and mandates.
Note: During disassembly, cap all hoses and fittings to
prevent fluid loss and contamination of the system flu-
ids.
1. Lower the lift arms to the ground.
2. Turn the engine start switch to the OFF position.
3. Relieve hydraulic pressure from the auxiliary cir
cuit.
4. Drain the hydraulic fluid. Refer to Chapter 16.
Hydraulic Fluid and Filter Change.
9-4