Lift Arm Bushing Removal And Installation; Upper Friction Points - Terex PT-30 Service Manual

Compact Track Loader
13. Loader Disassembly and Assembly
Lift Arm Bushing Removal and
Installation
The tools required for lift arm and lift arm bushing
removal and installation are listed in Table 13-3. Use
manufacturer-recommended tools whenever
possible.
Table 13-3
Required Tools
Socket
Dead Blow Hammer
Combination Wrench
Crescent Wrench
Mechanical Support
Lifting Device
Pry Bar
Lift Arm Bushing Placement
Lower
Friction
Point
Figure 13-19

Upper Friction Points:

Note: Each worn bushing will be removed one at a
time.
Figure 13-20
1. Lower the lift arm to the chassis stops. Then
attach suitable lifting device to them as shown,
to secure them during the procedure.
Bushings
2. Turn the engine start switch to the OFF position
and remove the key to avoid accidental start.
Figure 13-21
3. Remove the bolts from each side of the lift arm
that secure the pins to the chassis.
Upper
Friction
Point
Figure 13-22
4. Remove the pins from each side of the chassis.
Figure 13-23
5. Raise the lifting device until arm has cleared the
chassis and the hydraulic hoses. Use a pry bar
to guide the lift arm upward if necessary.
6. Inspect the bushings for wear according to the
procedure in page 16-6, step 3. If it is
determined that replacement is needed,
continue onto step 7 of this procedure.
13-6
Pry bar