Quick Attach Disassembly And Assembly; Chapter Overview; Personal Safety; Machine Preparation - Terex PT-30 Service Manual

Chapter Overview

This chapter provides disassembly and assembly
procedures for the quick attach assembly.

Personal Safety

Improper or incomplete maintenance/repair of a Compact
Track Loader can be dangerous and may result in
machine damage, injury or death.
Do not attempt to perform any type of repair or
maintenance on a Compact Track Loader until you have
read and fully understood the information in this manual.
Refer to the Operation and Maintenance manual for
instructions regarding proper machine operation
techniques before operating any Compact Track Loader.
Prior to performing any type of service work on a
Compact Track Loader, read and understand
Chapter 1 (Product Safety) for personal safety
information.

Machine Preparation

Accidental machine starting can cause injury or
death to personnel working on a Compact Track
Loader.
As a precaution, disconnect the battery cables from
the battery terminals, tape the battery clamps and
remove the key from the ignition switch prior to
performing any service work on a Compact Track
Loader.
Place a "Do Not Operate" tag prominently on the
machine to inform personnel that the machine is
being worked on.
Disassembly and Assembly
Quick Attach Disassembly and
Assembly Procedures
Disassembly and assembly procedures are provided
for the following quick attach components.
•
Latch Mechanism
•
Quick Attach Assembly
Note: Procedures are provided for only those quick attach
components listed above. However, information for
removal and installation of other quick attach components
can be obtained from the machine specific parts manual.
Latch Mechanism Removal
and Installation
The tools required for latch mechanism removal and
installation are listed in Table 14-1. Use
manufacturer recommended tools whenever
possible.
Table 14-1
Required Tools
Socket/Combination Wrench
Latch Mechanism Assembly Removal
1. Remove any attachments and place support
blocks beneath the quick attach. Then tilt the
quick attach assembly forward and lower the lift
arms until the quick attach assembly rests
securely on the blocks (approximately 6 inches
off the ground).
Figure 14-1
14-1
14. Quick Attach